Overhang issue with pod
What am I doing wrong here this is on the Snapmaker using petg. This the back top corner pieces. When I pull off the support there is near zero layer adhesion under them.
105 Views
top of page
Snapmakers, & Such
Public·90 members
Members
1 Month Member
First Supporter
TOP Commenter
bottom of page
well i tried printing supports in pla with 0 top z distance exact same outcome. So right now its at 100% fan speed on overhangs do i need to lower that down? the rest of the print is pretty much flawless except the bottom which also sites on a support because this piece is printed at a angle.