Corner piece help
Well it’s taken forever but I’m almost done with the pod build. However I’m struggling with the upper back corner pieces. I finally got an near flawless print of them and realized the edges aren’t true. The edges that attach to the back plate aren’t straight and curve inwards toward the piece causing a gap. Is this caused by external changes in room temp that ironically would be solved by an enclosure or something else?im printing these on the u1 have found I have to print these piece at about 100 mms or slower or I get z banding. I’m using pla as a interface layer which solves my wall overhang issues. But I’m at a loss on this. You can’t even tell till you try to put it together.
15 Views
