Snapmakers, & Such

Built two DRWR's (LEDs are installed but haven't yet set up the ESP32). To make them stay seated, I made custom rubber feet with a pad ring, then just used some 3M Thin Double Sided Clear Adhesive Tape.

EDIT:

Print Files here:

https://www.printables.com/model/1799509-stacking-feet-for-snapmaker-u1-for-double-cc3d-drw

On the underside is a plate holder from Printables... holds four plates.

Here's one of the test feet being held in place for the photo... it gets stuck on with the tape.

Here's one of the feet sitting in place on the top of the lower DRWR waiting for me to take the tape protection off and lower the top drawer into place. It's already taped into the recess on the lower DRWR's top.

MY COLOR COMPARISONS - I used Tinmorry Light Grey